How To Press

Position Your Design

Place your transfer in the desired location and ensure you are not pressing over large wrinkles. Using heat-resistant tape is recommended when pressing on hats or using a household iron to prevent the transfer from moving but you do not "NEED" to do this. With experience, you'll learn when this is needed.

Press

Press the transfer at 275°F / 135°C with high pressure for approximately 10-15 seconds. It is always recommended to test one piece first. Use parchment paper or a protective guard sheet to prevent your garment from directly touching the iron. Sometimes, for certain materials, it is necessary to adjust the temperature or pressure. With a bit of practice, you’ll find the right settings for each garment and material.

Let it Cool, Then Peel

After pressing, let your transfer rest until it is cool to the touch (15-30 seconds for hot peel films and 30-60 seconds for cold peel films). Peel slowly to ensure every piece of your design adheres as you peel. This helps ensure that every part of your design is sticking to your item. If parts of the design are not adhering, lay it back down and press again with added pressure and heat (+15°F). If still unsuccessful, continue increasing the heat by 15°F increments until it works. Repeated pressing won't damage the transfer.

Second press

Important: While most other DTF companies advise you to press it just once, this is incorrect. After hundreds of wash tests, we have discovered that a second press is essential to create a superior product. After transferring the design onto the garment and peeling off the film, cover the design with parchment paper or a single layer of t-shirt material and press for approximately 15 seconds. This step enhances your product's value by significantly improving its durability and softness while reducing the shine. For a glossy finish, use a guard sheet for the second press.

How to know if everything went well

Adhesion Check: All parts of your design are firmly adhered to the fabric, with no peeling or air bubbles.
Fabric Texture: After the second press, you should see the texture of the fabric on the print, indicating that the pressure was sufficient.
Softness: The design should feel soft to the touch and not too stiff.
No Shine: If you aimed for a matte finish, the shine should be minimal or absent.
Following these indicators, you can ensure that the process was successful.